Uniden BC785D User Manual
Page 68
64
Fleet Map Programming
If you have programmed a trunk tracking bank for Motorola press SCAN to start Multi-Track,
you will see user IDs display on the display. Since the BC785D defaults to Type II systems,
all the IDs will appear as numbers. However, if you notice a mix of odd and even user IDs,
for example 6477, 2560, 6481, 6144, 1167, etc., then you are probably monitoring either a
Type I or Hybrid systems. These systems are applied only when STATUS BIT is OFF (see
page 66).
You may also notice that you are missing responses when you hold on an active ID. Unlike
Type II, Type I/Hybrid systems require a Fleet Map that sets specific Fleet-Subfleet
parameters. It is easy to select a Fleet Map for your scanner; what is not always easy is
selecting or programming a map that matches your particular area.
There are 16 preset Fleet Maps listed in the appendix that you can choose, and these are
usually a good place to start when setting up a Type I/Hybrid trunk tracking bank. If you
choose a preset map and still have difficulty following complete conversations, then you'll
have to program your own Fleet Map.
Selecting Preset Fleet Map
1. Select 2:TYPE1 for the Trunk Type. (Refer to "Selecting or
Changing Trunking System Type" on page 46.)
2. Select the map you want to program by rotating the VFO
and pressing E.
The scanner returns to the other programming items.
Note: You will now begin to see Type I Fleet-Subfleet IDs. For
example, 100-12, 100-9, 000-12, 400-8, etc.
See "User Defined Fleet Maps in the Appendix" for more information about Type I
IDs.
How do you know if the preset map is correct? You will have to listen to see if you're
following complete conversations.
If not, you should try another preset map.
Programming a Fleet Map
You may want to read "User Defined Fleet Maps" in the Appendix before programming a
Fleet Map. It contains a detailed explanation of Scanner Fleet Map Programming, as well as
a table listing the Fleet Map Size Codes.
1. Select 2:TYPE1 for the Trunk Type. (Refer to "Selecting or
Changing Trunking System Type" on page 46.)
M 001
867.8375 NFM
1:TYPE2 800
2:TYPE 1
M 001
867.8375 NFM
SELECT FLEET MAP
PRESET 1
M 001
867.8375 NFM
1:TYPE2 800
2:TYPE 1
BC785D 11/8/2 1:01 PM Page 64