Uniden BC785D - Manual (Page 73)

4. Replace the cover and tighten the screw.
5. Turn on the scanner, and APCO P25 CARD INSTALLED appears on the display.
Installation is completed. You can monitor APCO Project 25 systems.
To use P-25 Card, you must program each setting for Conventional mode or Trunking mode.
- Conventional mode – See “Storing Frequencies into Channels in Menu mode” page 26-27.
- Trunking mode – See “Programming and Receiving Digital and Trunked Systems” page
46-48.
Precautions for Installing the BCi25D Card
1. Do not touch the BCi25D card without first removing the static electricity from your body.
To do this touch any metal object to release static electricity build-up before you touch
the BCi25D card.
2. Turn OFF the scanner, before inserting the BCi25D card into the slot.
3. Hold the BCi25D card by its edges when inserting it into the slot.
4. Do not touch any of the terminals. The BCi25D is a sensitive electrical device.
5. Do not operate with an open expansion slot door. This exposes the circuitry to dust and
other environmental particles that causes the unit to function improperly.
6. When you remove the BCi25D card, pull out the card by the ribbon.
Turning ON/OFF the APCO P-25 Card
Once the P-25 Card has been installed, the P-25 Card will be actively turned “ON”. To turn
the P-25 Card “ON” or “OFF” follow these instructions:
1. Press MENU.
2. Select 3:SYSTEM OPTION / 0:P-25 CARD by rotating the VFO and pressing E.
3. Select 0:P-25 CARD / 1:ENABLE or 2:DISABLE by rotating the VFO and
pressing E for your desired operation.
☞ Remember! You can also use ▲ or ▼ instead of rotating the VFO.
Also instead of pressing E, you can press the VFO control.
69
EXPANSION SLOT
13.8V REMOTE
BC785D 11/8/2 1:01 PM Page 69