Universal Remote Control (URS) UR3-SR2 - Manual (Page 6)

4
STEP2 Press the [DEVICE] button and the [SELECT]
button simultaneously for three seconds. The
device LED will turn on indicating that it is ready
to be programmed. The LED will remain on for 20
seconds. The next step must be entered while
the LED is on.
STEP3 Point the remote control toward the equipment
and alternately press the [CH+] (or [CH-]) button
and the [MUTE] button. If the right code number
is sent, the equipment will turn off.
*Note : You can verify that you selected the correct code
by pressing the [MUTE] button again. The
equipment should turn On or Off.
STEP4 Press the same [DEVICE] button to store the
code. The Device LED will blink twice to confirm
that the code has been stored.
C. C. T T o find the Thr o find the Thr ee-Digit Code that W ee-Digit Code that W as as
P r P r o g r a m m e d u s i n g t h e A u t o S e a r o g r a m m e d u s i n g t h e A u t o S e a r c h c h
Method Method
STEP1 Press the appropriate [DEVICE] button and the
[SELECT] button simultaneously for three
seconds. The device LED will turn on for 20
seconds. The next step must be performed while
the LED is on.
STEP2 Press the [INFO] button. The device LED will blink
a number of times indicating the number of each
digit for the code. Each digit is separated by a
one second interval of the LED being off.
Example : One blink, then three blinks, then eight blinks
indicates the code number 138.
*Note : Ten blinks indicates the number 0.