Uniden TITANIUM 24-148 - Manual (Page 11)

[ 9 ]
GETTING ST
ARTED
CCo on nn neecctt tth hee b baassee u un niitt
1 1 Connect the telephone line cord
to the TTEELL LLIIN NEE jack and to a
telephone outlet.
2 2 Connect the AC adapter to the D DCC
IIN N 9 9V V jack and to a standard 120V
AC wall outlet.
3 3 Set the base unit on a desk or
tabletop. Place the handset on the
base unit as shown. Then raise the
antenna to a ver tical position.
• Place the power cord so
it does not create a trip
hazard or where it could
become chafed and
create a fire or electrical
hazard.
• Use only the supplied
AD-313 AC adapter.
Do not use any other
AC adapter.
• Connect the AC adapter
to a continuous power
supply.
M Mo od du ullaarr
If your telephone outlet isn´t modular, contact your
telephone company for assistance.
CCh ho oo ossee tth hee d diiaalliin ng g m mo od dee
Depending on your dialing system, set the P PU ULLSSEE--TTO ON NEE switch as follows:
If you aren´t sure of your dialing system,
make a trial call with the PULSE-TONE switch
set to TTO
ON NEE.
If the call connects, leave the switch as is;
other wise, set to P
PU ULLSSEE.
IIff yyo ou urr d diiaalliin ng g ssyysstteem m iiss SSeett tth hee ssw wiittcch h tto o
Tone TTO ON NEE
Pulse P PU ULLSSEE
G E T T I N G S TA R T E D
• Place the base unit close
to the AC outlet so that
you can unplug the AC
adapter easily.
UC772EZ ENG(24-148) 10/9/01 15:23 Page 9