United States Stove Company 58242 - Manual (Page 4)

4 USSC
Specifications
Input Rating 38,500 BTU/hr
Heat Output 1 30,000 BTU/hr.
Efficiency 78%
Heating Capacity 2 850 sq. ft.
Fuel Burn Rate 3 3.5 lbs./hr. ±5%
Burn Time (lowest setting) 11-1/2 hrs. ±5%
Hopper Capacity 40 lbs.
Heating Specifications
Height 33-1/2 in.
Width 18-1/4 in.
Depth 19-1/4 in.
Dimensions
1 BTU output will vary depending on the quality of fuel. Use PFI listed fuels for the best results.
2 Heating capacity will vary depending on floor plan layout of your home, degree of insulation, and the outside temperature.
3 Pellet size may effect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as much as 20%. Use PFI listed fuel for best results.
Electrical Rating 110-120 volts, 60 HZ, 4.5 Amps
Watts (maximum) 520 (approx.)
Electrical Specifications
FUEL CONSIDERATIONS
Your Pellet stove is designed to burn premium hardwood pellets that comply with Association of Pellet Fuel Industries
standards. (Minimum of 40 lbs density per cubic ft, 1/4” to 5/16” diameter, length no greater than 1.5”, not less than 8,200
BTU/lb, moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per million). Pellets that are
soft, that contain excessive amounts of loose sawdust, or that have been or are wet will result in reduced performance.
Due to the different fuel densities and sizes, the fuel feed rate may vary. This may require an adjustment to the slider
damper setting or the auger feed trim setting on low.
SAFETY AND EPA COMPLIANCE
Your Pellet stove has been safety tested and listed to ASTM E 1509, by OMNI-Test Laboratories, Inc. Portland, Oregon,
USA. It is also certified and tested to EPA Phase II requirements.