Uniden XSA965 - Manual (Page 36)

USING
YOUR
PHONE
Page 28
REMOTE ACCESS AWAY FROM HOME
You can operate your answering system from a remote location using any touch-tone telephone. Use this
function to check for recorded messages, to play or delete messages, even to record a new greeting
message.
1. Call your telephone number.
2. During the greeting message, press and enter your PIN code (Factory Setting: 80).
(See "Setting a Personal Security Code", page 20)
3. The answering system announces the current time and the number of messages stored in memory.
Then you hear "To play incoming messages, press . For help, press ".
4. You may continue to listen to the Help Guidance, or you may select a command from the following
chart:
You must enter a
command within
15 seconds of
entering command
waiting mode or
the answering
system
automatically
hangs up and
returns to standby.
Command Function
1
2
3
4
5
then RepeataMessage
then PlayingIncomingMessages
then SkippingaMessage
then DeletingaMessage
then StopOperation
*For Memo Record and Greeting Message Record function, the first time you enter the corresponding
command, it starts the Recording function. If you want to stop the recording, enter the command again.
5. After all of the Help Guidance prompts have played, you hear intermittent beeps indicating that the
system is in the command waiting mode. You may enter another command at this time from the
chart.
6. When you are finished, hang up to exit the system. The answering system automatically returns to
standby.
Command Function
6
7
8
9
0
then AnsweringSystemOn
then MemoRecord/Stop*
then GreetingMessageRecord/Stop*
then AnswerSystemOff
then HelpGuidance
2 0