Ultratec Miniprint 425 - Manual (Page 30)

Setting the Baudot code baud rate
Each time you turn on the Miniprint 425, the Baudot code
baud rate is set to the auto setting.The auto setting uses
whatever code it needs to answer a call. If you need to
specify the code that the Miniprint 425 uses, you can set the
unit so that it will only use either 45.5-baud or 50-baud
Baudot code.When you do, the Miniprint 425 will not try to
use other codes. Follow these steps to change the Baudot
code baud rate setting:
1. Press the options key ( + ).You will see PRINT
(UP/LOW) CASE on the display.
2. Press the key until you see BAUDOT (AUTO) BAUD
on the display.
3. Press the to choose one of the following:
• AUTO to automatically use either 45.5 baud Baudot
code or Turbo Code.
• 45 to use only 45.5-baud Baudot code. Most Baudot
TTYs use 45.
• 50 to use only 50-baud Baudot code.TTYs purchased in
Australia, New Zealand, and South Africa use 50-baud
Baudot code. Note that in order to use 50-baud Baudot
code, you must change the setting to 50.The Auto
setting does not use 50-baud Baudot code.
4. Press the key to save the new setting and leave
options.
The Baudot code baud rate setting always returns to auto
when you turn off the Miniprint 425.
Esc
Spacebar
Return
3 Ctrl
2 8 • O P T I O N S