Univex OHDADJ - Manual (Page 4)

STEP 1:
4
• Insert the GUIDE ROD (4) thru the SHAFT COLLAR and one 2” OD RUBBER WASHER (28) on the LOWER BENCH FRAME (5)as
shown in FIGURE 1.
• CAREFULLY slide the GUIDE ROD (4) through the HOUSING on the UPPER BENCH FRAME (1). (NOTE: Allow the GUIDE ROD (4)
to push the plastic tube out of the end of the HOUSING.) See FIGURE 1.
5
29
4
1
• Insert the GUIDE ROD (4) through one 2” OD RUBBER WASHER (28) and into the second SHAFT COLLAR on the LOWER BENCH
FRAME (5) as shown in FIGURE 1.
• SECURE the GUIDE ROD (4) to the SHAFT COLLARS on the LOWER BENCH FRAME (5) using two 5/16 X 3/8” SET SCREWS (29)
as shown in FIGURE 1.
• Push the 2” OD RUBBER WASHERS (28) up against both the SHAFT COLLARS on the LOWER BENCH FRAME (5) as shown in
FIGURE 1.
REMOVE TAPE FROM BOTH ENDS
OF THE HOUSING
28
FIGURE 1