Uniden BC898T - Manual (Page 39)

36
Duplicate Frequency Alert
If you enter a frequency already stored in another channel, the scanner beeps and the
other channel appears. Press
.
on the keypad to start again or press E again to store the
frequency in both channels.
Deleting a Stored Frequency
To delete a stored frequency, press 0 then press E. Channels with no frequencies are
automatically locked out.
Programming a Channel With a CTCSS/DCS Tone
1. Press MANUAL.
2. Press CTCSS/DCS.
3. Select the channel you want to program then press E. If you have already programmed
a CTCSS or DCS tone, the frequency for the tone blinks. Otherwise, 000.0
HZ
blinks.
4. Enter a CTCSS tone.
a. Use the keypad, rotary tuner, or HOLD U or LIMIT V to select the tone.
b. Then press E.
Notes:
• If you make a mistake while entering a tone with the keypad, press
.
on the keypad
twice and enter the tone again.
• Make sure FREQ is lit before turning the rotary tuner to select a frequency.
5. To cancel CTCSS mode, press CTCSS/DCS or MANUAL. The CTCSS indicator and
displayed tones are turned off but not deleted.