Press e then press src, Press e, Repeatedly press hold r or limit s to select usr – Uniden BC898T User Manual
Page 46: Press e. the next available block appears, Press src
43
Selecting a Preset Fleet Map
1. If you are still in the programming mode, press DATA. Otherwise, select the trunking
programming mode and bank you want to change. Then, repeatedly press HOLD U or
LIMIT V
until E1 appears, then press E.
2. Repeatedly press HOLD U or LIMIT V
until FLEET appears, then press E.
3. Repeatedly press HOLD U or LIMIT V
to select the fleet map you want. For example,
E1P2.
4. Press E then press SRC.
The scanner exits the trunking programming mode, acquires the data channel, and begins
searching using the preset fleet map you chose.
Note: You will now begin to see Type I Fleet-Subfleet ID’s. For example, 100-12,100-9,
000-12, 400-8, etc. See “User Defined Fleet Maps” on Page 55 for more information about
Type I ID’s.
How do you know if the preset map is correct? You’ll have to listen to see if you are
following complete conversations. If not, try another preset fleet map.
Programming a Custom Fleet Map
You might want to read “User Defined Fleet Maps” in the Appendix and use the “Motorola
Trunking Worksheet” included in the help file included with the free demo software
(download at http://www.uniden.com) before programming a custom fleet map. “User
Defined Fleet Maps” includes a detailed explanation of scanner fleet map programming, as
well as a table listing the fleet map size codes.
1. If you are still in the programming mode, press DATA. Otherwise, select the trunking
programming mode and bank you want to change.
2. Repeatedly press HOLD U or LIMIT V
until E1 appears.
3. Press E.
4. Repeatedly press HOLD U or LIMIT V
until FLEET appears, then press E.
5. Repeatedly press HOLD U or LIMIT V
to select USR.
6. Press E.
7. Enter the size code for the first block by repeatedly pressing HOLD U or LIMIT V
until
the correct size code appears.
8. Press E. The next available block appears.
9. Repeat Steps 7 and 8 until you have selected a size code for each block.
For specifics about each size code, see “Size Code Restrictions” on Page 55.
10. Press SRC.
The scanner exits the trunking programming mode, acquires the data channel, and begins
searching using the map you’ve programmed.