Ultratec 50DX20B - Manual (Page 26)

26
USING THE REMOTE TO CONTROL DVD FUNCTIONS
NOTES:
1. If your DVD Player cannot be operated after performing the above procedures, your DVD Player’s code has not been pre-
coded into the remote.
2. In the unlikely event that your DVD Player cannot be operated after performing the above procedures, please consult your
DVD Player operating guide.
3. The remote control will remember the codes you have programmed until the batteries are removed from the remote control.
After replacing the batteries repeat the entire programming procedure as stated above.
NOTE: Refer to instruction manual of the DVD Player for operation of the buttons exclusively for the DVD Player.
Operating the precoded function for your DVD Player.
This remote is designed to operate different types of DVD Players. You must first program the remote to match the remote system
of your DVD Player. (refer to page 28)
1. Turn ON your DVD Player.
2. Aim the remote control at the front of your DVD Player.
3. Press the DVD/VCR button to switch to the DVD Player pre-coded mode.
4. Hold down the DVD/VCR button on the remote, enter the two digit preset code that matches your DVD Player as shown on page
28. The remote will turn off your DVD Player when the correct two digit preset code is entered. When this occurs, the remote
control is programmed for your DVD Player. If the DVD Player does not turn off after five seconds, try a different two digit pre-
set code.
5. The remote will now control your DVD Player.
PRECODED DVD buttons
These buttons always transmit
the chosen precoded DVD codes.
When the remote is in DVD mode,
EXIT button is used as ENTER
button.
1 2 3
4 5 6
7 8 9
0
INPUT STATUS
VOL CH
POWER
TV CBL/SAT DVD/VCR
PIP
SWAP MOVE
FREEZE
HELP MENU
MUTE
EXIT
LAST CH
REC TV/VCR PIX
SELECT
PIP CH
EXCLUSIVE TV buttons
These buttons are for
operating the TV.
DVD button
This button allows the remote to
control your DVD Player by setting
it to DVD mode.