Setting the current time, Setting the alarm clock, Using the backlight – Uniden UBC340CRS User Manual

Page 17: Country mode (australia/new zealand), Using the alarm clock, Setting up the scanner

Advertising
background image

6

Using the Alarm Clock

Using the Alarm Clock

Your scanner’s Clock displays whenever you turn off the radio functions.
It can also be used as a standard alarm clock.

Setting the Current Time

Follow the steps to set the current time:

. Move the slide switch to

Clock Set.

The hour digits flash.

. Press s or t to change the hour by one

hour increments or press the number keys
to select the present hour. Then press
E/PGM to set the hour. The minutes digits
flash.

. Press s or t to change the minute setting by one minute or press the

appropriate number keys to enter the minutes. The seconds reset to
00. Press

E/PGM,

AM/PM

flashes.

4. Press s or t to select AM or PM. To make your selection, move the

slide switch to

Clock. The scanner exits the clock setting mode.

Setting the Alarm Clock

Follow these steps to set the alarm time:

. Move the slide switch to

Alarm Set.

The hours digits flash.

. Press s or t to change the hour by one

hour increments or press the number keys
to select the present hour. Then press
E/PGM to set the hour. The minutes digits
flash.

. Press s or t to change the minute setting by one minute or press the

appropriate number keys to enter the minutes. Press

E/PGM to set the

minutes. The

AM/PM

display icon flashes.

4. Press s or t to move from AM to PM and back. Press

E/PGM to

make your selection. To lock in the alarm time, move the slide switch
to

Clock.

CAUTION: Be sure to follow all safety warnings provided with the
antenna. Failure to do so could expose you to risk of injury or death and
could severely damage the scanner.

Using the Backlight

To turn on the backlight for 5 seconds, tap

SNOOzE/Backlight. To turn

on the backlight permanently, press and hold

SNOOzE/Backlight for over

 seconds. To turn off the backlight, press and hold

SNOOzE/Backlight

again.

Country Mode (Australia/New zealand)

The UBC40CRS is set to the Australian mode by default.

Australian mode: Australian service search frequencies and TV channel
frequencies.

New Zealand mode: New Zealand service search frequencies and TV
channel frequencies.

The country mode can be switched between Australia (AUS) and New
Zealand (nL) as follows:

. Turn on the power while pressing down the

[HOLD] key.

The display will momentarily show

AUS for Australian mode or nL for

New Zealand mode.
The country mode is remembered for the next power on.

. To change the country mode again, repeat step .

Setting Up The Scanner

UBC40CRS OM.indd 6

7/5/08 4:8:5 PM

Advertising