Uniden BCD996T User Manual
Page 82
82
This setting determines the frequencies you need to enter for Motorola systems.
Select your setting, then press
F
.
On — You only need to enter control channel frequencies.
Off — You must enter all voice and control channel frequencies.
Note: The scanner defaults to On.
[MENU]
Program System
F
Select a trunked system
F
Edit Site (current)
F
Select a site
F
Set LocationInfo
F
This setting control whether the system is automatically enabled and disabled
when you connect a GPS to the scanner.
Set Latitude — Enter the system’s latitude using the format you selected in the
system settings.
Set Longitude — Enter the system’s longitude using the format you selected in
the system settings.
Set Range — Set the system’s range using the units you selected in the system
settings.
Set GPS Enable — Depending on the data received from the GPS, the L/O
status of the site is automatically controlled.
[MENU]
Program System
F
Select a trunked system
F
Edit Site (current)
F
Select a site
F
Adjust P25 Level
F
This setting determines some site-specific parameters for digital channels. In most
cases, setting this to Auto provides the best performance. However, you can also
manually set the digital decode threshold. This setting affects all channels in the
current site. See “Optimizing P25 Performance” on Page 52.
Setting Site Location Information
MESL
Adjust P25 Level
MEL