Ultimate Technology 600 POS - Manual (Page 12)

Series 600 POS Keyboard
7
EXTERNAL CONNECTIONS
As required by the hardware configuration, connect the keyboard to its host computer and other
peripheral devices as shown in Figures 2 and 3. Note that the specific use for each connector on
the keyboard is marked adjacent to each connector. Depending on the make and model of the
user's equipment, the following cables and/or adapters may need to be supplied by the user to
complete the installation:
Standard 6-foot cable, 6-Pin Modular to 6-Pin Modular - UTC Part No. CAB20137 or equivalent
Keyboard adapter 2-Inch, 5 Pin DIN Male to 6-Pin Mini DIN Female - UTC Part No.900-0839 or equivalent
Keyboard adapter 12-Inch, 5 Pin DIN Female to 6 Pin Mini Din Male - UTC Part No. 901-5009A or equivalent
CASH DRAWER JUMPER CONNECTIONS (PRINTER FIRED)
As shown in Figure 3, the Series 600 Keyboard has two status cash drawer ports. Each port is
selectable by use of the jumper connector located next to the MAIN keyboard connector. This
jumper connector is used to make the keyboard compatible with the different printer and cash
drawer connections required by various manufacturers. NOTE: JUMPERS COME
UNINSTALLED. FALURE TO PROPERLY SET JUMPER COULD DAMAGE KEYBOARD.
Jumper pin set A and B is used with cash drawer 1: pin set C and D is used with cash drawer 2.
Installing the jumper on the B (drawer 1) and D (drawer 2) side of the connector causes the status
signal from the cash drawer to be applied on pin 2 of the related cash drawer port. Installing the
jumper on the A (drawer 1) and C (drawer 2) side of the connector causes the status signal from
the cash drawer to be applied on pin 6 of the related cash drawer port which allows pin 2 to be
used to open the drawer. Shown below are the pin connections for the cash drawer ports for each
position of jumper. Identified by an "X" are the jumper setting used with typical Epson and Ithaca
Peripheral devices.
PRINTER 1, 2 PINOUTS
DRIVER 1, 2
DRAWER 1, 2
JUMPER ON A OR C SIDE
DRAWER 1, 2
JUMPER ON B OR D SIDE
1 - SOLENOID GND 1 - SOLENOID GND 1 - SOLENOID GND
2 - SOLENOID GND/STATUS + 2 - SOLENOID GND 2 - STATUS +
3 - STATUS GND 3 - STATUS GND 3 - STATUS GND
4 - SOLENOID + 4 - SOLENOID + 4 - SOLENOID +
5 - SOLENOID GND 5 - SOLENOID GND 5 - SOLENOID GND
6 - NO CONNECTION 6 - STATUS + 6 - STATUS +
EPSON/AHIOHM X
ITHACA SERIES 50,60 X
ITHACA SERIES 80, 80, 150 X