Uniden BC 278CLT - Manual (Page 39)

36
Problem Solution
■ Check the connections at both ends of the
AC Adapter.
■ Turn on the wall switch of your room.
You could be using an outlet controlled by the
wall switch.
■ Move the AC Adapter to another wall outlet.
■ Scanner won’t power up.
■ Poor reception. ■ Check antenna connection.
■ Move the antenna.
■ If the programmed frequency is higher than
406MHz, a shorter antenna length may improve
the reception.
■ Relocate the scanner.
■ You may be in a fringe area. This could require
an optional multi-band antenna. Check with your
dealer or local electronics store.
■ Scan won’t start. ■ Press the SCAN key again.
■ Adjust the Squelch control.
■ Check to see if 100 channels are locked out. If so,
unlock the channels as needed.
If your BC278CLT is not performing properly, try the following steps.
TROUBLESHOOTING
BC278clt.qxd 3/8/00 7:34 PM Page 36