U-Line CO29FF - Manual (Page 13)

CO29FF 13
Figure 19
5. Install hinge on opposite side, bottom of cabinet
(Figure 19). Replace nut on back side where installed.
Align hinge outer edge with cabinet before tightening
screws.
Figure 20
6. Relocate plastic spacer/bushing (Figure 20, 1) on
bottom of door to opposite side, and place door on
bottom hinge pin. Clean out bushing hole in door
bottom with a screwdriver if needed.
Figure 21
7. Remove plastic hole plug from door handle and
relocate on opposite side (Figure 21).
8. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge (Figure 21).
Figure 22
9. Remove three plastic screw plugs in hinge holes, top of
cabinet, opposite side; being careful not to scratch
cabinet (Figure 22).
10. Place door on lower hinge pin. Invert and install upper
hinge on door.
Figure 23
11. Fasten upper hinge to unit (three screws) (Figure 23).
Partially tighten screws until door is aligned.
12. Adjust door to assure proper seal. Tighten upper hinge
screws securely.
13. Replace three plastic plugs removed in Step 10 into
holes on top of unit. Replace screws in holes in bottom
of unit, opposite side.
14. Re-inspect door seal and alignment. Adjust if needed.
Figure 24
ULINE_0217_A
1
ULIN_0109_A
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
ULIN_0142_A
ULIN_0144_A
ULIN_0145_A
ULIN_0214_A
1
2
ULIN_016357_30099.fm Page 13 Monday, March 27, 2006 10:22 AM