Uniden DCT7488 - Manual (Page 19)

G E T T I N G S T A R T E D [ 1 8 ] w w w . u n i d e n . c o m
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. In the rare situation that
you suspect another cordless telephone is using the same security code, you can
change the code. To change the digital security code:
1. De-register the Handset (see page 29).
2. Re-register each handset by following the steps on page 17.
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the
handset. Press down until it clicks.
To remove the beltclip
Pull either side of the beltclip to release the tabs from the
holes.
Optional Headset Installation
Your phone may be used with an optional headset. To use this
feature, insert the headset plug into the headset jack. Your
phone is ready for hands-free conversations. (Headset may be
purchased by calling the Uniden Parts Department or visiting
the web site. See page 79.)
•If you have more than
one handset, de-register
all the handsets you
have.
•If you de-register
another handset,
perform "Replacing the
Base Setting" for the
handset after you de-
register it (see page 29).
note
GE
T
T
I
NG S
T
A
R
T
E
D