Venturer KLV39120 - Manual (Page 28)

- 27 -
TV SETUP
TV Channel Setting
1. Press the TV MENU button.
2. Use the or button to select TV CHANNEL SETTING.
3. Use the or button to select the options (Antenna /
Auto Scan / Auto Scan Add CH / Channel Skip /
Channel No. / Channel Label).
4. Use the or button to make adjustment. The screen will
change to your selected mode immediately. Press the TV
MENU button to return to the previous menu.
5. Repeat steps 2 to 4 to adjust other options.
6. To exit the TV SETUP MENU and return to the normal
screen, press the EXIT button on the remote control.
NOTE: Channel No. : 2-69 Channel for Air, 1-135 Channel for
CATV.
Channel Label: You may edit one label for each channel.
1. Select the Channel Label item and press the or button
to go into the channel label edit screen.
2. Use the or button to enter the number or letter.
3. Use the or button to move and edit for the next
character.
4. After editing, press the DISPLAY button and the Channel
& Channel Label will be shown on the screen.
Antenna : Select “CATV” to receive cable signal.
Select “AIR” to receive air signal.
Auto Scan : Automatically search all channels for
those with adequate signal strength.
Auto Scan Add CH: The stored channels can not be cleared
and the Auto Scan Channels will be
added.
If you has selected CATV in TV
CHANNEL SETTING, then you can
select Cable System (AUTO / STD /
HRC / IRC) in the sub menu as the
picture shown.
Channel Skip: You may switch ON/OFF the skip
function of each stored channel by
selecting the channel with or button
(and using or button to select page
if the amount of stored channels in
more than 1 page), and followed with
pressing the ENTER button.
Auto Scan Add CH
Channel Skip
Channel No.
Channel Label
UP/DOWN ADJUST “MENU”:EXIT
Antenna
Auto Scan
CATV