Vizio D-5.5E - Manual (Page 13)

AC Power Cord
(6 ft.)
Pushbutton Circuit Breaker
(1A)
(PUSH RESET)
This breaker is designed to
protect the D-5.5E in the
event of internal or external
fault. Wait about two mi-
nutes after correcting the
fault and push the button to
reset the system and restore
proper operation.
MIDI Thru Connectors
(MIDI THRU)
The MIDI signal from the
MIDI input connector (MIDI
IN) is split and sent un-
altered to the four MIDI Thru
connectors on the D-5.5, and
to six more MIDI Thru con-
nectors on the D-5.5E, if
used. Each of the MIDI Thru
jacks can be connected to a
different synthesizer's MIDI
input jack, allowing one
MIDI keyboard or sequencer
to control up to four other
MIDI synths. (ten when using
the D-5.5E and sixteen when
using the two D-5.5E's.)
Earth Terminal
Balanced XLR Microphone
Input (MIC)
Phantom Power Switches
(PHANTOM 9~20)
1/4" Phone Channel
Input (INPUT)
RCA Pre Accessory
Patch Points
(PRE IN/OUT)
RCA Post Accessory
Patch Points
(POST IN/OUT)
Direct Output
(DIRECT OUT)
RCA Tape Input
(TAPE IN)
* The names of the functions on the D-5.5E are specified below as connection of the
input channel on the D-5.5 is the same as the D-5.5E. Difference in functions and
connection are explained.
Rear Panel (D-5.5E)
Buss Link Connector
(BUSS LINK OUT)
This connector is used to
link the D-5.5E Expander
with the D-5.5. A six-foot
connecting cord is included
with the D-5.5E.
Buss Link Connector
(BUSS LINK IN)
This connector is used to
link the D-5.5E Expander
with another D-5.5E Expan-
der.
— 14 —