VTech VT 1511 - Manual (Page 21)

21
Setup
• Plug AC adapter into a standard
electrical outlet and base unit.
• Plug Power cord of remote charging
stand into a standard electrical
outlet. Let headset battery pack
charge for 16 hours before first
use.
• Set TONE/PULSE switch on
underside of base unit.
• Connect the telephone line cord to
the base unit and telephone jack.
Making Calls
From the base unit:
•
Lift the handset and dial a call
normally.
• To end the call hang up
From the wireless headset:
•
Put on the wireless headset.
• Flip the microphone down to the
ON position. You should hear dial
tone.
• Using the infrared dial card (with
the keypad facing you) dial a call
normally.
• To end the call, flip the microphone
up to the OFF position, or using the
dial card, press OFF.
Answering Calls
From the base unit:
•
Lift the handset and talk.
• To end the call, hang up.
From the wireless headset
• Put on the wireless headset.
• Flip the microphone down to the
ON position and talk.
• To end the call, flip the microphone
up to the OFF position, or using the
dial card, press OFF.
To Place a Call on Hold
From the base unit:
•
During an active call, press the
HOLD key. To return to the call
press HOLD again.
From the wireless headset:
•
During an active call, press the
HOLD key on the dial card. To
return to the call press HOLD again.
Making an Intercom Call
From the base unit:
•
Lift the handset and press the
INTERCOM key. The base unit will
ring the wireless headset up to five
times, unless the person using the
headset answers the intercom call.
• This feature can also be used to
locate the headset.
From the wireless headset:
Note: The microphone must be in the
down position, and the headset must
have been turned OFF using the dial
card, prior to making an intercom call.
•
Using the dial card (with the keypad
facing you) press the INT.C key.
• The headset will ring the base unit
up to five times, unless the person
using the base unit answers the
intercom call.
Storing Speed Dial Memory
Note: Speed Dial Memory can only be
programmed from the base unit, but
can be dialed from either the base unit
or wireless headset.
• The phone must be OFF and the
corded handset should be cradled.
• Press the PROGRAM key.
• Enter the 2 digit memory location
where you want to store the number
(00 to 20).
QUICK REFERENCE GUIDE