Vizio TWRS-I - Manual (Page 22)

Turn the Receiver Module Off and On
1. To turn the receiver module Off, press and hold the Adjust button until two dashes are
displayed (approximately 5 seconds), then release.
2. To turn the receiver On, press the Setup button two times. The receiver will return to the
normal display mode within approximately 10 seconds.
Set or Restore the Sensor Address Code
The receiver and sensor modules are factory-matched to communicate using a specific address
code. If you have purchased a new sensor module or if it becomes necessary to reset the address
code, use the following procedure to enable communication:
1. Press and hold the Smart Bypass button until all three
Water Conservation indicators are illuminated and the Setup
icon begins blinking (approximately 15 seconds). See Figure 28.
2. Activate the sensor module at close range by pressing the test
spindle until the Sensor Status indicator is illuminated, then release
the test spindle. Refer to step 3 of “Initial System Test” on page 8
for additional information.
Note: If the Water Conservation level is set to Medium or Maximum, or the Dry Out feature is in
use, the sensor system will be activated. Press the
Smart Bypass button to reset the
receiver to the Monitor mode.
20
Figure 28
373-0372a_E/S/F 6/7/05 1:59 PM Page 20