ViewCast Osprey-450e - Manual (Page 44)

Setting Driver Properties
38 ViewCast

If the content format is a rapidly changing mix of telecine and video, or is all video, or is
of unknown type, the Motion Adaptive setting gives the most consistent results. The
quality of telecine sequences is not the best possible, but there are no instances of
frames not deinterlaced at all due to telecine re-locking.
Device tab
Device controls (Figure 33) are less often used items. Unless specifically noted, changes made on this
page apply to all filters and all video previews and capture pins on the currently selected device. Unless
noted, different settings may be set and stored for different devices.
Figure 33. Device tab
The Device tab has the following controls.
No-Video Test
Pattern This control lets you select a pattern to display when no video signal
is present.
Buffers
Requested The driver indicates the minimum number of video capture buffers
needed to allocate for proper operation.
Diagnostic
Logging For use by ViewCast Technical Support Only.
Extras … Click this button to display the Extras dialog box (see Extras).
Device Info … Click this button to display the Device Info dialog box (see Device
Info).
OK Click OK to accept the settings.
Cancel Click Cancel to reject the settings and close the window.