Viper 5500 User Manual
Page 26
23
©
2006 Directed Electronics—all rights reserved
When you are ready to drive the vehicle:
1. Insert the ignition key and
turn it to the ON (not the
START) position.
2. Press the brake pedal.
NOTE: If the brake pedal is pressed before the key is in the ON position,
the engine will shut down.
While the vehicle is running during remote start operation, the
system will monitor the vehicle and will automatically shut down the
engine if the system receives any of the following shut-down
inputs:
■ The brake pedal is pressed.
■ The hood is opened.
■ The shutdown toggle switch is put into the OFF position.
■ The pre-programmed run time (12, 24, or 60 minutes) has
elapsed.
■ Transmitter button
is pressed again twice to start the
vehicle.
To turn the rear defogger output OFF:
1. Simultaneously press & release the
+
+
but-
tons on the remote control.
2. The lights will flash 2 times.
3. The rear defogger output will no longer activate when the
vehicle is remote started.
Rear Defogger