VDO Dayton CD 2327 G - Manual (Page 25)

25
Eng
lish
SOFTWARE ACCESS MENU (SAM)
It is possible to customize your headunit settings to your personal preferences via the SAM. To navi-
gate the SAM, here are the steps:
Short-press the SAM
AST
button to enter the SAM.
Short-press or button to select the next SAM menu item; or short-press the or but-
ton to select the previous SAM menu item.
Turn the knob clockwise or counter-clockwise to choose the desired option.
Long-press the SAM
AST
button to exit the SAM.
Note: The headunit will automatically exit SAM after 6 seconds of inaction.
Option Setting
Usage
(◄/▼ or ►/▲) (turn the knob)
TAVOL [1 to 26] Select the volume level of Traffic Announcement, News bulletins
and Alarm messages.
START [1 to 26] Limit the starting volume when the headunit is turned on (to pre-
vent sudden loud surprise to the driver especially)
If the last-volume (before the headunit is turned off) is higher
than the starting volume or muted, then after turning on, the
turn-on volume is limited at the starting volume
If the last-volume is lower than the starting volume (except
muted), the turn-on volume will be at the same level as the
last-volume


CD LEVEL [-2, -1, 0, +1, +2] Select the Compact Disc volume offset relative to the tuner volume
CA LEVEL [-2, -1, 0, +1, +2] Select the Compressed Audio (MP3 or WMA) volume offset relative
to the tuner volume
AUX LEVEL [-2, -1, 0, +1, +2] Select the Auxiliary volume offset relative to the tuner volume
BT LEVEL [-2, -1, 0, +1, +2] Select the Bluetooth volume offset relative to the tuner volume
BEEP [OFF, ON] Activate / Deactivate the confirmation beep tone
SDVC [OFF, 1, 2] Select the Speed Dependent Volume Control (SDVC) compensa-
tion level (only when pin A1 is connected and calibrated; please
refer to the ‚INSTALLATION‘ page)
Level 1 gives a smaller increase (in volume) while level 2 gives
a greater increase (in volume) with respect to the vehicle’s
speed

SWRC [OFF, ON] Activate / Deactivate the steering wheel remote control
TEL MUTE [OFF, LO, HI] Select the logic level of your connected hands-free car kit (HFK)
mute cable
Select ‘TELM OFF’ if no HFK is connected
Select ‘TELM LO’ if the incoming HFK mute signal is at 0V
Select ‘TELM HI’ if the incoming HFK mute signal is at 12V
Please refer to the instruction manual of your purchased HFK.



CLOCK [OFF, RDS,
MAN]
Select ‚CLOCK RDS‘ to activate the RDS clock or ‚CLOCK MAN‘ to
set the clock manually.
Note: Selecting ‚CLOCK OFF‘ will disable the clock display when
the headunit is in stand-by / off mode; hence, it will help prolong
your battery.
CLOCK SET
(available
when 'CLOCK
MAN' is se-
lected)
[12H hh:mm,
24H HH:MM] If ‚CLOCK MAN‘ is selected, this menu item is available for cus-
tomization.
Short-press or button to select the 12H/24H-digit,
hour-digit or minute-digit
Rotate the knob to adjust the selected digits





