Vizio WB-31 - Manual (Page 6)

WB-31
Page 6 Installation Instructions
Backplate Installation - Concrete Surface
NOTE: These installation instructions will apply to the WB-31 Swingout Arm Mount.
The following steps will outline how the back plate will be mounted.
1. Determine where the mount location will be.
2. After this has been determined, line-up the holes of the backplate.
NOTE: Be sure that the end of the back plate that has a lip is pointing as shown in (Figure 3).
3. Once the mounting holes are marked on the wall, use a 5/16” drill bit and drill 4 holes into the
concrete surface (Figure 3).
4. Once the holes have been drilled, gently tap the anchor studs into each hole, until the washer is flush
(even) with the concrete surface.
5. Place the backplate onto the concrete surface and slowly tighten each nut onto its respective anchor
stud (Figure 4).
Figure 3. Backplate - Concrete Surface Figure 4. Backplate Installation - Concrete
Surface
Lip Lip