VTech 912 User Manual
VTech Phones
Advertising
Table of contents
Document Outline
- Table of Contents
- INTRODUCTION
- IMPORTANT SAFETY INSTRUCTIONS
- REPLACING THE HANDSET BATTERIES
- GETTING STARTED
- Setting Up Your VTech 912 ADLc
- Choose an area near an electrical outlet and a telephone wall jack.
- Connect the telephone line cord.
- Plug the AC power adapter into an electrical outlet and the DC connector to the back of the base unit.
- Set the TONE/PULSE switch on the base unit.
- CHARGE THE HANDSET BATTERIES BEFORE USE.
- CHECK FOR A DIAL TONE.
- CAUTION:
- Setting Up Your VTech 912 ADLc
- WALL MOUNTING
- HANDSET FEATURES
- BASE UNIT FEATURES
- OPERATING INSTRUCTIONS
- Making Calls
- Answering Calls
- Disconnecting
- Changing Channels
- Temporary Tone
- Programming The Ringer Type
- Turning Off The Ringer
- Checking The Ringer
- Memory Dialing
- Programming Speed Dial Numbers
- Speed Number Dialing
- To Change or Replace a Speed Dial Number
- Storing Special Codes
- Using Redial
- Storing a Redial Number into Speed Dial
- The Page Feature
- CALLER ID
- Caller ID LCD and Icons
- New Call Icon (NEW CALL)
- Call Counter (CALL#)
- Repeat Counter (RPT#)
- DATE / TIME Stamp
- Message Waiting Icon (MSG)
- Number Display Area
- Dot Matrix Area
- CallerID Operating Key Descriptions
- Caller ID Setup
- Reviewing Caller ID Information
- Repeat Counter
- Deleting Caller ID Memory
- Manual Reset
- MAINTENANCE
- IN CASE OF DIFFICULTY
- THE PHONE DOESN’T WORK AT ALL.
- NO DIAL TONE.
- YOU GET NOISE, STATIC, OR A WEAK SIGNAL EVEN WHEN YOU’RE NEAR THE BASE UNIT.
- YOU GET NOISE, STATIC, OR A WEAK SIGNAL WHEN YOU’RE AWAY FROM THE BASE UNIT.
- THE HANDSET DOES NOT RING WHEN YOU RECEIVE A CALL.
- YOUR CALLER FADES IN AND OUT.
- YOU HEAR OTHER CALLS WHILE USING YOUR PHONE.
- YOU HEAR NOISE IN THE HANDSET, AND NONE OF THE KEYS OR BUTTONS WORK.
- COMMON CURE FOR ELECTRONIC EQUIPMENT
- WARRANTY STATEMENT
- FCC REGULATIONS
- TECHNICAL SPECIFICATIONS