Sony KV-29FQ75K - Manual (Page 7)

3
Installation
3. Connecting the TV
The scart lead is
optional. If it can be
used however, this
additional
connection can
improve picture and
sound quality when
in play mode.
1. Connect your existing aerial lead to your VCR as shown.
2. Connect the VCR aerial lead from the RF OUT socket on the back of the VCR to the aerial
socket on the back of the TV as shown.
3. Connect the VCR set to the mains and switch on.
4. Insert a pre-recorded tape into the VCR and press the ‘PLAY’ button.
1. Connect your existing aerial lead to the socket marked on the rear of the TV set.
Connecting an aerial to your TV
Connecting an aerial and VCR to your TV
If you are not connecting
your TV to a VCR,
please connect the aerial
lead (as shown left) and
proceed to section
‘4.Switching on the TV’.
If you are connecting
your TV to a VCR please
refer to the section
below.
OUT
IN
AERIAL
ANTENNA AC IN
scart lead
(not supplied)
existing aerial lead