Vinotemp VT-36 - Manual (Page 9)

9
1 7 6 3 1 S . S u s a n a R o a d , R a n c h o D o m i n g u e z , C A 9 0 2 2 1
[email protected]
INSTALLATION INSTRUCTIONS
Before Using Your Appliance:
•
Remove the exterior and interior packaging.
•
Before connecting the appliance to the power source, let it stand
upright for approximately 2 hours. This will reduce the possibility of
a malfunction in the cooling system from handling during
transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Install the handle on the door.
Installation of Your Appliance:
•
Use two or more people to move and install appliance. Failure to do
so can result in back or other injury.
•
Place your wine cooler on a floor that is strong enough to support it
when it is fully loaded.
•
Choose a well-ventilated area with temperatures above 50°F and
below 90°F.
•
The appliances are designed to be for built-in, recessed or free
standing installation.
•
For free standing installation, 1 inch of space for the back and ¼
inch for each side of the unit is needed. This allows the proper air
circulation to cool the compressor and condenser.
•
Even for built-in installation, must keep space on each side and at
the top. If you plan to use the units in a built-in application please
follow the requirements shown below:
Cabinet Opening Dimensions (minimum)
Width 24”
Depth 25”
Height 33”
•
The appliance must be installed with all electrical, water and drain
connections in accordance with state and local codes.
•
Make certain that the pipes are not pinched, kinked or damaged
during installation. Check for leaks after connection.