Vestax CDX-16 - Manual (Page 11)

INPUT SELECT SWITCH
Used to select the input source (Phono, Line, CD) sent to the
designated PGM (A,B).
MONITOR SELECT SWITCH
Used to select the signal for monitoring (headphone). Selection is
made irrespective of the position of the crossfader and can be set to
either PGM A, B or to Mix. The selected PGM monitor signal can
be heard through the left (side) headphone whilst the main output
signal is heard in the right headphone. When set to MIX the master
signal can be monitored through both headphones in stereo.
INPUT LEVEL METER
This LED indicates the current level of each input signal for both
PGM A and PGM B.
PGM EQ VOLUME
Used to adjust the EQ, Hi (high) Lo (low) frequencies for each
PGM.
PGM VOLUME LEVEL
Used to control and adjust the input level of each PGM.
CROSS FADER
With the cross fader to the left, the output signal is PGM A.
Therefore, when the cross fader is to the right the output signal is
PGM B. As the cross fader is moved from one side to the other
there is a blend of the respective signals. This is such that when the
fader is in the neutral (center) position both signals can be heard.
The cross fader on the CDX-16 is user replaceable. When the cross
fader is worn out the fader may be easily removed and subsequently
replaced with the optional replacement fader
CF-R3 Likewise,
preventative maintenance & cleaning of the fader may be
accomplished through such easy removal.
To replace the crossfader please follow the below instructions carefully.
( i ) Carefully remove the four (4) screws that fix the crossfader to the faceplate.
(ii) Gently remove the crossfader, making sure to disconnect all cables carefully.
(iii) Replace the crossfader unit, making sure to carefully connect all cables to their proper points.
(iv) Affix the crossfader unit to the faceplate with the previously removed four (4) screws.
MIC INPUT JACK
Input jack for MIC.
MIC VOLUME LEVEL
HEADPHONE JACK
Input jack for MIC.
MONITOR VOLUME LEVEL