Vermont Castings FK28/2960 - Manual (Page 3)

3 30000275
Jefferson Installation Procedure
1. Attach the snapstat assembly to the snapstat bracket
with two sheet metal screws. (Fig. 8) Remove the
1/4-20 x 3/8” hex head bolt installed in the hole in the
right rear ledge of the firebox. Use that bolt to secure
the snapstat bracket to the firebox. The mounting
hole is slotted to allow you to adjust the bracket so
that the snapstat bracket head makes contact with
the firebox. (Fig. 9)
2. Attach the fan to the rear shroud by engaging the
upper flange of the fan skirt under the lower edge of
the shroud and se cure the skirt with the four screws
and one star washer provided. (Fig. 9,10)
3. The rheostat control switch attaches to the left side
of the valve bracket at the front of the stove. (Fig. 11)
• Remove the plug from the rheostat bracket.
• Insert the switch box shaft through the hole in
the back of the right side of the valve bracket,
aligning the locator pin with the smaller hole in
that bracket.
• Attach the retaining nut to the switch control shaft
to secure it to the plate.
• Attach the control knob to the rheostat shaft.
• Use the wire tie to secure the fan and rheostat
wire harnesses together.
ST239
FDV attach snapstat
12/13/99 djt
1/4-20 x 3/8”
Phillips Screw
1/2”
Sheet
Metal
Screw
Snapstat
Snapstat Bracket
ST239
Fig. 8 Snapstat assembly and installation.
ST240
FDV attach fan
12/13/99 djt
Upper
Flange
To
Control
Valve
ST240
Fig. 9 The upper flange of the fan skirt should be located
behind the lower edge of the shroud.
ST240
FDV attach fan
12/13/99 djt
ST241
Fig. 10 Correct position of fan skirt installation.
ST347a
JUV
FK28
rheostat install
9/21/00
Retaining Nut
Control Knob
ST347a
Fig. 11 Attach rheostat.
Rheostat