VIEWSONIC V 37 - Manual (Page 80)

9LHZ6RQLF 3RFNHW 3& 9 
)ROORZ WKLV SURFHGXUH WR FOHDU WKH PHPRU\ IURP \RXU 9
 Disconnect all cables, including the AC adapter, from your V37.
 Unscrew the cap at the top of the stylus. Use the pointed tip of the cap to
push the battery switch to the OFF (up) position.
 Wait for three (3) minutes then push the battery switch to the ON (down)
position.
 The Notification indicator will flash red for approximately 30 seconds, and
then your V37 will automatically turn on and display the Welcome Wizard
screen.
NOTE: If the battery runs completely out of power and is not re-charged in
time, the memory of your V37 will be cleared.
3RZHU 3UREOHPV
3RZHU GRHV QRW WXUQ RQ ZKHQ XVLQJ EDWWHU\ SRZHU
• The remaining battery power may be too low to run your V37. Connect the
AC adapter to your V37 and to external AC power. Then, turn on your V37.
(Charge the battery whenever possible to avoid running out of battery
power.)
%DWWHU\ UXQV RXW RI SRZHU TXLFNO\
• You might be using your V37 in ways that drain power quickly. (See
“Managing Power” in Chapter 3 for tips on saving power.)