Vanguard VI33PRA - Manual (Page 15)

110150-01B
For more information, visit www.desatech.com For more information, visit www.desatech.com
15
15
INSTALLATION
Continued
INSTALLATION
Installing 9-Volt Batteries
OPERATING FIREPLACE INSERT
For Your Safety Read Before Lighting
Lighting Instructions
Figure 30 - Installing Battery in Remote Receiver
INSTALLING 9-VOLT BATTERIES
Two 9-volt batteries (not included) are required to operate this
heater with the wireless hand-held remote control set. Install one
battery in the receiver and one in the hand-held remote control unit.
Note: Only use alkaline batteries.
Installing 9-Volt Battery (Not Included) in Receiver
1. Locate back of receiver under front burner of heater.
2. Locate the battery clip mounted on the back of the receiver.
3. Slide a 9-volt battery through the clip.
4. Attach the terminal wires to the battery.
Battery Clip
9-Volt Battery
Terminal
Wires
Remote
Receiver
Installing 9-Volt Battery (Not Included) in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote control unit.
2. Attach terminal wires to the battery. Place battery into the bat-
tery housing.
3. Replace battery cover onto remote control unit.
Model
GHRCTA
Figure 31 - Installing Battery in Hand-Held Remote Control Unit
Battery
Cover
Terminal
Wires
Remote
Control Unit
9-Volt
Battery
Battery
Housing
Model
GHRC
OPERATING FIREPLACE
INSERT
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing prop-
erty damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand.
When lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area
for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in
your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire de-
partment.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don’t try to repair it, call a qualified service techni-
cian or gas supplier. Force or attempted repair may result
in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
LIGHTING INSTRUCTIONS
WARNING: You must operate this heater with the
fireplace insert screen in place. Make sure fireplace
insert screen is installed before running fireplace insert.
NOTICE: During initial operation of new fireplace
insert, burning logs will give off a paper-burning
smell. Open damper or window to vent smell. This will
only last a few hours.
1. STOP! Read the safety information above.
2. Make sure equipment shutoff valve is fully open.
3. Set switch to OFF position.
WARNING: Burners will come on automatically
within one minute when the remote selector switch is
in the ON position after the pilot is lit.