Vanguard Heating UNVENTED (VENT-FREE) NATURAL GAS LOG HEATER - Manual (Page 14)

14 105273
UNVENTED NATURAL GAS LOG HEATER
VANGUARD FLAME MAX ®
It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place one-piece log set on grate to fit
as illustrated in Figure 16. Make sure
middle section at bottom of log set is
seated into "U"-shaped cutout in cen-
ter of chassis (see Figure 16). Log will
fit securely on chassis.
Note: 36" model
has more features but fits on the chas-
sis the same.
IMPORTANT: Make sure
log does not cover any burner ports.
2. Place lava rock around base of heater.
Figure 16 - Installing Golden Oak One-Piece Log Set
Figure 17 - Installing Golden Oak One-Piece Log Set (Top View)
WARNING: Failure to posi-
tion the parts in accordance with
these diagrams or failure to use
only parts specifically approved
with this heater may result in prop-
erty damage or personal injury.
INSTALLING LOGS
INSTALLATION
Continued
One Piece
Log Set
Burner
ports
One Piece Log Set
Burner
Middle
Section at
Bottom of
Log Set
"U"-shaped
Cutout in Chassis
Chassis
CAUTION: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flames contact any log. If so, re-
position logs according to the
log installation instructions in this
manual. Flames contacting logs
will create soot.