Assembly and set-up, Installation of balance weight, N o t e – Vestax PDX-d3S User Manual
Page 7
6
Installation of Turntable Platter
Method of Using Slip Mat
Installation of Cartridge
Never connect the AC power plug before assembly has
been completed.
1
By placing the turntable platter on the center spindle, the platter
adjusts to match the spindle by itself.
2
Place the slip mat on the platter.
3
Extra care should be taken to avoid damaging magnet by
dropping it.
1
Place slip mat on the turntable platter, and place the record on
the slip mat. It is possible to stop and return the record by hand
while the turntable revolving.
R e d (R+)
Right Channel+
Green (R-)
Right Channel -
White (L-)
L e f t Channel+
B l u e (L-)
L e f t Channel -
1
In accordance with the instructions of the cartridge, install a
cartridge properly.
2
Connect the lead wires to the cartridge terminals. The terminals
of most cartridges are color corded. Connect each lead wire to
the terminal of the same color.
1
Place the balance weight on the rear shaft of the tone-arm
winding the balance weight clockwise.
N O T E
In case the cartridge weight is less than 8g, it is
necessary to fix the attached shell weight on the
cartridge.
N O T E
NUT
SHELL
SHELL WEIGHT
CARTRIDGE
LEAD WIRE
TERMINAL
STYLUS
SCREWS
ASSEMBLY AND SET-UP
Installation of Balance Weight
Surface of slip mat (printed): Disk side
Inside of slip mat : Slip side