VocoPro PKJ-9090PRO - Manual (Page 16)

15
9. MICROPHONE INSERTS - These jacks are for connecting out-board effects units. The audio from
the MIC channels are routed out from the INSERT jacks to your out-board effects unit(s) and routed back
with the effects applied, using only a single cable. In order to use these jacks, you will need appropriate
TRS (tip = send, ring = return, sleeve = signal ground) insert cables.
10. GROUND TERMINALS - These TERMINALS are for connecting ground wires. If you are experiencing
line noise, attach wire from here to your other devices or similar suitable surface.
11. VIDEO OUT 1, 2, 3 - These jacks send graphics from input source player video output to video display
device(s) such as TVs, TFTs and Monitors. Connect video cables from these VIDEO OUT jacks to the
VIDEO IN jacks on your video display device(s).
12. VIDEO IN 1, 2, 3 - These jacks allow the video component of CD+G, DVD, VCD and LD players to be
connected to the PKJ-9090PRO. Connect video cables from the VIDEO OUT jacks on your player(s) to
these VIDEO IN jacks.
13. REMOTE KEY CONTROL - This 1/8” jack is for connecting a REMOTE KEY CONTROL cable. Remote
Key Control allows you to make key changes at a distance from the Digital Key Controller on the PKJ-
9090PRO.
14. CD INPUT 1, 2, 3 - Use these dedicated inputs for CD players as source music with RCA L/R
cables. Adjust the STEREO CHANNEL SOURCE toggle on the middle panel of the PKJ-9090PRO
accordingly.
13
14
9
BOOTH OUT
MASTER OUT REC OUT
remote
key control
VIDEO OUT VIDEO IN
AV OUT AV INPUT STEREO INPUT MICROPHONE INSERTS
1 2 3 4
PHONO
LINE
GND
B alanced
UNBAL RECORD AUDIO AV3 AV2 AV1 PHONO 3 CD 3 CD 2 CD 1 PHONO 2 LINE PHONO 1 LINE
+
-
+
-
10
11 12
Rear Panel (Mixer) Descriptions
and Functions Cont...