M-AUDIO Delta RBUS - Manual (Page 23)

activating the Stereo Link checkbox will link (or "link") the left/right
faders so that both channels may be adjusted together as a stereo pair.
Patchbay/Router Page
The Patchbay/Router page allows you to connect each of the Delta
R-BUS’s hardware outputs (4 pairs of R-BUS outputs and 1 pair of analog
output channels that is identical to the S/PDIF digital output) to specific
audio sources within the Delta R-BUS board. To display this page, click
the "Patchbay/Router" tab of the Delta Control Panel.
ON THE MAC : Please substitute the name “SM/ASIO” where
referrences are made to “WavOut.” SM/ASIO are the software outputs
on the Mac, while WavOut are the software outputs on the PC.
The leftmost vertical column of Patchbay/Router page, "H/W Out 1/2,"
connects this R-BUS stereo pair to one of eight stereo sources:
1. The default setting, "WavOut 1/2", connects R-BUS ports OUT1 and
OUT2 to your music software or Windows multimedia applet. In other
words, when music software plays audio to the device named "WavOut
1/2 Delta-R-BUS" it will be routed directly to the "hardware" R-BUS
outputs 1 & 2 of your R-BUS 25-pin connector.
2. The second option, "Monitor Mixer", connects R-BUS ports OUT1 and
OUT2 to the outputs of the Delta R-BUS monitor mixer. For more
information of the capabilities of the monitor mixer, please see the
section "Monitor Mixer Page".
3. The third option, "SP/ANA In", connects R-BUS ports OUT1 and OUT2
directly to the hardware Analog or S/PDIF inputs on the Delta R-BUS
PCI host card (whichever input is selected in the Hardware Settings
page will be the active input). The left channel of the S/PDIF In is routed
to OUT1 and the right channel of the S/PDIF In is routed to OUT2.
4. The fourth option, "SP/ANA In (L/R Rev.)", functions identically to the
third option, except that the left and right channels are swapped.
Therefore in this mode, the left channel of the Analog or S/PDIF input
(as selected in the Hardware Settings page) is routed to OUT2 and the
right channel of the Analog or S/PDIF input is routed to OUT1.
5. Selections five through eight connect the hardware R-BUS inputs 1 & 2, 3
& 4, 5 & 6, or 7 & 8 (respectively) directly to the Delta card’s hardware
R-BUS outputs 1 & 2. For example, if "H/W In 1/2" were selected, any
signal present at the IN1 port will be copied to OUT1, and any signal
present at the IN2 port will be copied to OUT2. This same behavior
applies to "H/W In 3/4", "H/W In 5/6", and "H/W In 7/8" when selected.
23