Verilux VA02 - Manual (Page 15)

Using the SNOOZE/RESET function
There are three ways of switching off the alarm – (Snooze,
24 Hour Alarm Reset, Canceling the Alarm.)
However, if the alarm is not turned off after at the end of the alarm
cycle, it will continue to operate for approximately 30 minutes (then
turn off automatically).
1. SNOOZE
This restarts your alarm cycle after a 9-minute interval.
• To activate, during the alarm, tap SNOOZE/RESET button. Note:
alarm will begin again at the dimmest/quietest setting and run for
the entire wake cycle.
2. 24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish
to retain the same alarm setting for the following day:
• For Sound only and Sound & Light mode: Press and hold the
SNOOZE/RESET during the alarm cycle until the sound goes off
and the “Alarm On” icon on the display stops flashing.
• For Light Mode only: Press and hold the SNOOZE/RESET during
the alarm cycle until the “Alarm On” icon on the display stops
flashing.
In either case, the light must be turned off manually by pressing the
light switch button.
3. CANCELING THE ALARM COMPLETELY
To cancel the set alarm modes entirely:
• Press the WAKE button until there is no WAKE alarm option
(Light, Sound) illuminated.
IMPORTANT – If the LIGHT or LIGHT & SOUNDS alarm
mode is selected, the light will remain on at the level when the
SNOOZE/RESET button is activated. To turn the lamp off, press
the light switch button
Snooze/Alarm Reset
14