Vinotemp VT12TEDS2Z - Manual (Page 9)

INSTALLATION INSTRUCTIONS
Before using your wine cellar
• Remove the exterior and interior packing
• Check to be sure the following parts are included:
o
For VT-12TEDS-2Z, 4 Slide out shelves
o
1 Instruction manual
o
1 Stainless steel handle
o
2 Screws/fasteners
• Before connecting the appliance to the power source, let it stand upright
for approximately 2 hours. This will reduce the possibility of a malfunction
in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
INSTALLING YOUR WINE CELLAR
• Place your appliance on a floor that is
strong enough to support the appliance
when it is fully loaded. To level your
appliance, adjust the front legs at the
bottom of the appliance.
• Cellar must be placed as a freestanding
unit—not to be built in.
• Installing the handle: The wine cooler
comes with 1 stainless steel handle. To
install:
1. Open door
2. Carefully remove seal from side of door where handle will be installed,
starting at the upper corner
3. Insert included screws through holes from back of door frame
4. Screw on handle
5. Replace seal into door frame
• For proper installation, keep away from direct sunlight and sources of
heat (stove, heater, radiator, etc.). Direct sunlight may affect the coating
and heat sources may increase electrical consumption. Extreme cold or
hot ambient temperatures may cause the appliance not to perform
properly.
• Not designed for placement in garage or basement. Designed for use
inside the home.
9 1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m