Venturer GB - 1 - Manual (Page 6)

GB - 5
acceSSorieS
reMote controL
using the remote control
• Point the remote control at the REMOTE SENSOR
located on the unit.
• When there is a strong ambient light source, the
perform ance of the infrared REMOTE SENSOR
may be degraded, causing unreliable operation.
• The recommended effective distance for remote
operation is about 16 feet (5 meters).
to change remote Battery
1. Open the battery door.
Take out the PVC sheet before operating the
Remote Control.
2. Insert one CR2025 (3V) size battery.
Remote Control (with battery)...........................................................................................................x 1
Car Power Adapter ...........................................................................................................................x 1
DC-AV Cable ....................................................................................................................................x 1
Mounting Strap .................................................................................................................................x 2
Please check and identify the supplied accessories.
Battery replacement
When the battery becomes weak, the operating distance of the remote control will be greatly reduced and
you will need to replace the battery.
Note:
• If the remote control is not going to be used for a long time, remove the battery to avoid damage caused
by battery leakage corrosion.
• When discarding batteries, environmental problems must be considered and local rules or laws governing
the disposal of these batteries must be strictly followed.
WARNING:
• Do not dispose of battery in fire; battery may explode or leak.
• Batteries should not be exposed to excessive heat such as sunshine, fire or the like.
CAUTION:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.