Viper 1100.5 - Manual (Page 10)

10
© 2002 Directed Electronics, Inc
TOP PANEL CONTROLS
1. IInnppuutt GGaaiinn AAddjjuussttm meenntt - Controls
amplifier sensitivity and is used to
match the input level of the ampli-
fier to the output level of the signal
source.
2. CCrroossssoovveerr FFrreeqquueennccyy AAddjjuussttm meenntt -
Adjusts the crossover point for the
on-board active crossovers.
3. SSuubb PPhhaassee SSw wiittcchh - Changes the
phase of the subwoofer speaker
output by 180 degrees
4. VVaarriiaabbllee BBaassss EEQQ - Adds 0 to12db of
additional boost to the subwoofer
output when active.
5. SSuubbssoonniicc FFrreeqquueennccyy AAddjjuussttm meenntt -
Adjusts the cutoff point for subsonic
frequencies. Frequencies below the
adjustment point will be attenuated
by 24db per octave.
6. VVaarriiaabbllee SSuubbssoonniicc FFiilltteerr SSw wiittcchh -
Turns the Variable subsonic filter
control on/off
7. CCrroossssoovveerr SSeelleeccttiioonn SSw wiittcchh -
Controls the type of filter for the on-
board active crossovers. FLAT does
not attenuate any frequencies and is
for full-range speaker systems. HPF
attenuates low frequencies and is
used for mid-range speakers and
tweeters. LPF attenuates high
frequencies and is used for
subwoofers speakers.
8. SSuubb IInnppuutt SSw wiittcchh - Controls where
the subwoofer section of the ampli-
fier gets its signal. If the SUB INPUT
switch is in the ON position the
subwoofer section of the amplifier
will get its signal internally summed
from the channels one through four
RCA jacks, and the SUB RCA jacks
do not need input. If in the OFF
position the SUB RCA jacks must
have input.
9. IInnppuutt PPaarraalllleell SSw wiittcchh - Controls the
input signal to the indicated chan-
nels. If the 3+4 switch is ON, chan-
nels three and four will derive their
signal from channels one and two
RCA jacks and no input is needed. If
the 3+4 switch is OFF, channels
three and four RCA jacks must have
input.