VIEWSONIC Wireless Presentation Gateway WPG-350 VS12526 - Manual (Page 61)

56
6-2 Troubleshooting
Scenario: Can’t connect to wireless presentation gateway
Solution:
1. Check the LED lights located at the front of WPG. If ‘Power’ LED does not
light, do the following check:
z
Check the connection of A/C adapter, and if the electrical outlet you used
with A/C adapter is functioning properly.
z Press ‘Power’ button on remote controller to see if ‘Power’ LED lights now.
2. Check the network connection.
3. Make sure you connected to correct IP address.
4. If you’re using wireless network, make sure you connected to correct device.
5. If you’re using wireless network, check the WEP / WPA password.
Scenario: Remote controller does not work
Solution: 1. Replace the battery of remote controller with a new one (CR-2032
lithium battery).
2. Please point the IR transmitter (located at the top of remote controller) to the
IR receiver of WPG.
3. Make sure the IR receiver of WPG (labeled as ‘Remote’) is not blocked by
any object.
4. If there’s strong / fluorescent light source near IR transmitter / receiver,
remote controller may not be able to function properly.
5. If the distance between IR transmitter / receiver is longer than 7 meters,
remote controller may not working properly.
WPG-350 ViewSonic