Velodyne Acoustics VELODYNE SUBCONTRACTOR (SC) SERIES SC-602 - Manual (Page 10)

7
.
w w w . v e l o d y n e . c o m
SC-602 Amplifier User’s Manual
Figure 3: Speaker-Level Connection.
(17) and (18) Subwoofer Connection 5-way Binding Post Terminals
Connect the output terminals to the subwoofer being controlled by the SC-602 amplifier. Only
connect ONE subwoofer to each red/black pair of subwoofer output terminals - DO NOT
connect multiple subwoofers to the terminals in any configuration.
Caution!!! To avoid damage to your SC-602 amp and subwoofer, be sure to maintain correct
polarity when making all speaker connections; red (positive) to red, and black (negative)
to black. Be sure that all connections are tight, and that there are no loose strands or
frayed wires.
(19) Power Cord Adapter
Connect the detachable power plug to this male interface connection. The detachable cord
allows for easy replacement should the original become damaged.
(20) Main Power Switch
Press the POWER switch to the ON position to activate the amplifier. If the unit is to be left
unused for an extended period of time, move this switch to the OFF position to prolong the
life of the amplifier.
(21) Fuse
If the unit is not functioning, check the fuse. If the fuse is blown, replace with an identically
rated fuse. If the fuse blows again, refer the unit for service.
Speaker-Level Signal
from Source
80 Hz and Above to
Satellite Speakers
SC-600
Subwoofer
SC-600
Subwoofer