Velodyne Acoustics VELODYNE SUBCONTRACTOR (SC) SERIES SC-602 - Manual (Page 5)

2
.
w w w . v e l o d y n e . c o m
SC-602 Amplifier User’s Manual
S C - 6 0 0 I W, S C - 6 0 0 I F / I C S U B W O O F E R S
SC-600 IW (In-Wall):
- Two high excursion 6.5” active drivers, two 12.5” x 3” oval
passive radiators with ribbed rubber surround
- High-excursion rubber surrounds on both active and passive drivers
- 2” 4 layer copper voice coils
- Frequency Response: 37-120 Hz (+/- 3 dB)
- 4 ohm impedance
SC-600 IF/IC (In-Floor/In-Ceiling):
- 12” (9.7” piston diameter) subwoofer
- 2.5” 4 layer copper voice coils
- Oversized spider for linearity at high excursion
- High-excursion rubber surround
- Frequency Response: 25-120 Hz (+/- 3 dB)
- 4 ohm impedance
Note: The SC-600 IW and the SC-600 IF/IC must be driven with either the SC-600 or SC-602
amplifier. Use of any other power source voids the warranty.
Be sure to do the following to ensure the best performance from your subwoofer:
❑ If possible, optimize the placement of the subwoofer(s) in the listening area.
See page 10 of the User’s Manual.
❑ Install and wire the subwoofer per the instructions on pages 3 - 8.
❑ Set the amp to the proper subwoofer model per the instructions on page 11.
❑ Select the proper volume level. See page 4.
❑ Select the proper low-pass crossover frequency. See pages 9 - 10.
❑ Equalize the subwoofer using the microphone and Auto-EQ feature. See page 12.
❑ Adjust the phase control on the remote to the correct setting. See page 12.
❑ Select the correct preset for the source material. See page 13 - 14.
Your new Velodyne subwoofer system provides for a number of installation options. Read all the
installation information below in order to determine which installation option is best for your
system. Remember to perform all installation procedures with system power turned off.
Note: For proper setup and installation of the SC-600 IW (In-Wall) subwoofer, please refer to
the SC-600 IW Quick Install Guide.
Se tup Checklis t