Warning – Viking Combination Beverage Center User Manual
Page 14
14
CLEANING AND MAINTENANCE
Any piece of equipment works better and lasts longer when maintained properly and kept clean.
C
Co
on
nd
de
en
nsse
err
The condenser tubing inside the cabinet does not require frequent cleaning; however, satisfactory cooling depends on
adequate ventilation over the coils. Be sure that nothing obstructs the required air flow openings in front of the cabinet.
Spiders and insects can nest in and around the combination beverage center/ice maker causing damage to the unit.
Frequently brush or vacuum lint and dirt from the condenser coils for efficient performance by unscrewing the grill on the
bottom front of cabinet.
C
Caab
biin
ne
ett
The cabinet can be washed with mild soap and water and thoroughly rinsed with clear water. Never use abrasive scouring
powders.
IIn
ntte
erriio
orr
Wash interior compartment with mild soap and water. Do not use abrasive powder, solvent, polish cleaner or undiluted
detergent.
S
Sttaaiin
nlle
essss S
Stte
ee
ell P
Paarrttss
All stainless steel parts should be wiped regularly with hot soapy water. Use a liquid cleaner designed for stainless steel
when soapy water will not do the job. D
Do
o n
no
ott u
usse
e steel wool, abrasive cloths, cleansers, or powders. Do not permit citrus
or tomato juice to remain on stainless steel surfaces, as citric acid will permanently discolor stainless steel.
B
Brraassss P
Paarrttss
C
CA
AU
UT
TIIO
ON
N:: All brass parts are coated with an epoxy coating. D
DO
O N
NO
OT
T U
US
SE
E B
BR
RA
AS
SS
S O
OR
R A
AB
BR
RA
AS
SIIV
VE
E C
CLLE
EA
AN
NE
ER
RS
S O
ON
N T
TH
HE
E
B
BR
RA
AS
SS
S P
PA
AR
RT
TS
S.. All brass parts should be wiped regularly with hot soapy water. When hot soapy water will not do the job,
use every day non-abrasive household cleaners.
D
Do
oo
orr G
Gaasskke
ett
The vinyl gasket may be cleaned with mild soap and water, a baking soda and water solution, or a mild scouring powder.
P
Paaiin
ntte
ed
d S
Su
urrffaacce
ess
Wash with warm soapy water. D
DO
O N
NO
OT
T U
US
SE
E steel wool, abrasive cleansers, ammonia, acids or commercial oven cleaners
which may damage the finish.
E
EN
NE
ER
RG
GY
Y S
SA
AV
VIIN
NG
G T
TIIP
PS
S
•Reduce door openings.
•Close the door as soon as you can.
•Keep the condenser coils on bottom of the unit clean. (See “Cleaning and Maintenance”.)
•Adjust the temperature control to a warmer setting when practical.
•Do not put hot foods in the unit.
•Install unit away from the stove or other heat sources.
This unit uses a 15-watt appliance bulb with an intermediate base located
inside the light shield. The light shield is on the back of the unit and is
held in place by the use of three screws. Remove the three screws and
light shield to remove the light bulb. DO NOT replace the bulb with a
bulb higher than 15 watts.
Light
Shield
Screws
LIGHT BULB REPLACEMENT
WARNING
ELECTRICAL FIRE HAZARD
Do not replace bulb with a bulb higher than 15
watts.