Victor Technology V12 - Manual (Page 68)

V I C T O R T E C H N O L O G Y
68
+ - 008, 40
Program is now stored
b P/R
0.00
Sets calculator to run mode
b P/R
0.00
Sets calculator to program mode
r GTO . 001
001, 36
Displays the first program line
5
002, 5
Displays the new information for program line 002: 3
has been replaced by 5 to enable the program to
calculate a 50% discount instead of 30%.
b P/R
0.00
Sets calculator to run mode
If the program is run with a starting value of 100, the result should now be 60
(50% off of 100 plus 10).
Inserting Instructions Into a Program
To insert new instructions into a program, a branch must be created because
the V12 does not have a mechanism to insert new program lines between
existing program lines.
Branching will allow you to go to a new instruction added at the end of the
program, then branch back and continue with the next program line after the
branch.
To add by Branching Method:
¾ Touch b P/R to enter PROGRAM mode
¾ Touch r GTO . then the 3-digit program line number directly
before the point where the additional instructions will go.
¾ To specify the line number of the new branch, touch . r GTO and
the three-digit line number where the branch will start. Suggestion:
Use the second line after the end of the program because the first