Vivitar Vivicam 3715 - Manual (Page 43)

42
E
Setup menu
You can select your preferences for the camera settings in SET-UP mode. Turn the
mode dial to SET-UP mode and navigate to the option you wish to configure by
using the
/ button.
Format
This option formats the internal memory (or
memory card) and erases all stored images and
data. To perform the format function, first press
the button. Then select [Yes] by using the
/
button and press O K . A progress bar
displays, showing the progress of formatting.
Beep
The camera makes a sound (beep) each time
you press the camera button if this function is
enabled. Press the button. Select [On] or [Off]
by using the
/ button and then press OK.
Power off
If the camera goes unused for a certain period
of time while the camera is powered on, the
camera will switch to an idle mode, and eventu-
ally turn itself off to conserve power.
Inactivity period Inactivity period Camera status
(batteries) (AC power adapter)
60 seconds 60 seconds stay idle
30 minutes 30 minutes shut off
If the camera is idle, re-activate the camera by pressing any button or switch the
mode dial. If the camera has powered-off you must turn the camera on again by
pressing the
button. The table (above) shows the default time settings for idle,
and power-off. To change the power saving interval, first press the button. Then
select the power-off interval you perfer by using the
/ button and press OK.
[3 min], [5 min], [10 min], [30 min]