VMware GSX 3 - Manual (Page 175)

C H A P T E R 5 Moving and Sharing Virtual Machines
175
Moving a GSX Server 2 Virtual Machine
If you want to move a virtual machine created with GSX Server 2, you may prefer to
upgrade it for full compatibility with GSX Server 3 before moving it. To do so, run the
virtual machine under GSX Server 3 and use VM > Upgrade Virtual Hardware. If you
upgrade the virtual hardware, you can then follow the instructions in
Moving a
VMware GSX Server 3 Virtual Machine on page 172 .
If you upgrade the virtual machine, you can no longer run it under GSX Server 2. If you
need to run the virtual machine under both GSX Server 2 and GSX Server 3, do not
upgrade the virtual hardware. Follow the instructions in this section.
Note: These instructions assume that you are using a virtual disk — stored in one or
more .vmdk files on your host computer.
It’s always safest to make backup copies of all the files in your virtual machine’s
directory before you start a process like this.
The following sections further describe moving a GSX Server 2 virtual machine:
• Virtual Machines Use Relative Paths on page 175
• Preparing Your Virtual Machine for the Move on page 175
• Moving a Virtual Machine to a New Host on page 176
Virtual Machines Use Relative Paths
The path names for all files associated with a virtual machine created under GSX
Server 2 are relative, meaning the path to the each file is relative to the currently active
directory. For example, if you are in the virtual machine’s directory, the relative path to
the virtual disk file is
<machine name>.vmdk .
If you intend to move virtual machines created in a VMware product other than GSX
Server 2 or higher, or Workstation 3.1 or higher, see
Moving Older Virtual Machines on
page 178 .
Preparing Your Virtual Machine for the Move
1. Use GSX Server 2 to connect to the virtual machine. If the virtual machine has
more than one virtual disk and if the virtual disks use different disk modes, you
must use the Configuration Editor (choose Settings > Configuration Editor) to
change one or more of the virtual disks so they all use the same mode.