VBrick Systems EtherneTV-NXG 2 - Manual (Page 6)

V B R I C K E T H E R N E T - N X G V O D Q U I C K S T A R T G U I D E V E R S I O N 2 . 0 . 0 E
C O P Y R I G H T V B R I C K S Y S T E M S P A G E 6 J U N E 2 3 , 2 0 0 4
You will be prompted for the following information:
1. The system hostname
2. The system ip address
3. The default gateway ip-address
4. The system netmask
5. The default network ip-address
6. The system broadcast address
7. The system domain
8. The dns server ip-address
Quit now, if you do not have this information.
Continue?
Please enter y or n
2. When booting is complete, type “Y” and Enter to continue.
Make sure the information from the “Before You Begin” section in the first part of this
procedure is available, then press Enter to continue.
Wait 5 to 8 minutes for the unit to fully power up.
3. Configure the EtherneTV-NXG
Verify that the required information has been obtained from Table 1 before
proceeding: