VIEWSONIC PJ1165 - Manual (Page 27)

ViewSonic PJ1165 26
PICTURE-2 Menu
With the PICTURE-2 menu, the items shown in the table below
can be performed. Perform each operation in accordance with the
instruct ions in the table below.
memo
This menu cannot be selected at a M1-D signal.
Item Description
V POSITION Adjust the vertical position using the S/T buttons.:
Up Down
memo
This item can be selected only at a RGB signal.
H POSITION Adjust the horizontal position using the S/T buttons.:
Left Right
memo
This item can be selected only at a RGB signal.
H PHASE Adjust the horizontal phase to eliminate flicker using the S/T
buttons.:
Right Left
memo
This item can be selected only at a RGB signal or a component
video signal other than a COMPONENT port input of 525i/625i/
SCART RGB.
H SIZE Adjust the horizontal size using the S/T buttons.:
Large Small
memo
This item can be selected only at a RGB signal.
memo
When this adjustment is excessive, the picture may not be
displayed correctly. In such a case, please reset the adjustment
pressing the RESET button during this operation.
OVER SCAN Adjust the over-scan ratio using the S/T buttons.:
Large Small
memo
This item can be selected only at a video signal.
memo
When this adjustment is too large, certain degradation may
appear at the frame area of the picture. In such a case, please adjust
small.
RESET Select the EXECUTE using the S button to reset the PICTURE-2
menu items.:
EXECUTE CANCEL
The items of the PICTURE-2 menu are collectively returned to the
initial setting. Note that the item “H PHASE” is not reset.