VIEWSONIC PJ751 User Manual
Pj751
Advertising
Table of contents
Document Outline
- FEATURES
- BEFORE USE
- INSTALLATION
- OPERATION
- OSD MENU FUNCTION DESCRIPTION
- MAINTENANCE
- TROUBLESHOOTING
- SPECIFICATIONS
- LIMITED WARRANTY
- Appendix
- For Your Records
- FEATURES
- BEFORE USE
- INSTALLATION
- OPERATION
- Power ON
- 1 Check to be sure the power cord is connected correctly.
- 2 Set the power switch to [I]. When the standby mode is selected, the POWER indicator is orange.
- 3 Press the STANDBY/ON button on the control panel or the remote control device. The warm-up star...
- 4 The POWER indicator stops blinking and turns green when the power is on.
- 5 Remove the lens cap.
- 6 Adjust picture size using the ZOOM Knob.
- 7 Adjust focus with the FOCUS Ring.
- Power OFF
- Selecting an Input Signal
- Adjusting Image Size and Focus
- Adjusting the Volume
- Temporarily Muting the Sound
- Adjusting the Image Position
- Using the Automatic Adjustment Feature
- Correcting Keystroke Distortions
- Using the Magnify Feature
- Freezing the Screen
- Signal Searching
- Selecting the Aspect Ratio
- Temporarily Blanking the Screen
- Using the Menu Functions
- Operating the PC Screen
- Available Functions
- Remote Control Operation
- Available Functions
- Remote Control Operation
- Power ON
- OSD MENU FUNCTION DESCRIPTION
- Main Menu
- Item
- Description
- BRIGHT
- CONTRAST
- ASPECT
- PICT. POSIT.
- GAMMA
- LANGUAGE
- Item
- Description
- COLOR BAL R
- COLOR BAL B
- SHARPNESS
- COLOR
- TINT
- Item
- Description
- V POSITION
- H POSITION
- H PHASE
- H SIZE
- OVER SCAN
- Item
- Description
- AUTO
- VIDEO
- HDTV
- SYNC ON G
- Item
- Description
- BLANK
- START UP
- MyScreen
- MyScreen Size
- MyScreen Lock
- Item
- Description
- VOLUME
- AUTO OFF
- WHISPER
- LAMP TIME
- FILTER TIME
- MAINTENANCE
- Lamp
- Lamp Life
- Replacing the Lamp
- 1 Switch the projector OFF, remove the power cord from the power outlet, then wait at least 45 mi...
- 2 Prepare a new lamp.
- 3 Check that the projector has cooled sufficiently, then gently turn it upside down.
- 4 Loosen the screw as shown in the diagram, then remove the lamp cover
- 5 Loosen the two screws, then gently remove the lamp while holding the grips. Touching the inside...
- 6 Install the new lamp then tighten the two screws firmly. Also steadily push the opposite side o...
- 7 Replace the lamp cover in position then tighten the screw firmly.
- 8 Gently turn the projector right-side up.
- Caring for the Air Filter
- 1 Turn off the projector, then unplug the power cord
- 2 To clean a reusable filter, carefully vacuum both sides of the filter area.
- 3 If the filter is damaged and needs to be replaced, contact your dealer or ViewSonic Corp. Repla...
- 4 To reset the Filter Timer, turn on the projector power, go to the Option menu then select filte...
- Caring for the Inside of the Projector
- Caring for the Lens
- Caring for the Cabinet and Remote Control Transmitter
- TROUBLESHOOTING
- SPECIFICATIONS
- LIMITED WARRANTY
- Appendix